Uvitron UV curing lamp

Fri, 03 Jul 2026 10:25:14 +0800

If you’re running an Anatol flash-dry line, you know the drill: hit your cycle time and cure depth targets without tearing the press apart. The lamp housing and ballast are what they are, so any upgrade has to drop in and play nice—electrically and mechanically. Uvitron UV curing lamps are built as direct-fit replacements for Anatol systems, with pin-to-pin wiring and the same footprint. The workhorse inside is a high-pressure mercury vapor lamp, tuned to match the photoinitiator window of UV offset, flexo, and screen inks. You get stable spectral output with strong peaks at 365 nm and 385 nm, delivering the photon flux needed for rapid cross-linking. Peak irradiance is set for short dwell, and the dichroic-coated reflector focuses the energy on the substrate instead of wasting it. The payoff is consistent curing energy across the sheet—no hot spots, no tail-end undercure. **Why it fits on an Anatol: it keeps your workflow intact.**Installation is clean—no rewiring, no control changes. You keep the same lamp envelope, connector, and mounting, and you gain tighter dose repeatability, less variance in cure depth, and fewer rejects from adhesion or blocking. Power draw stays inside the original design envelope, and lamp life follows a predictable output decay curve, so you can plan maintenance instead of chasing emergency changeouts. A couple of shop-floor details. Match the existing lamp length, arc gap, and connector type to the Uvitron datasheet before you order. Output is sensitive to reflector cleanliness and cooling airflow, so keep the original ducting and keep the reflector free of dust and ink buildup. And for best results, confirm your ink’s spectral response and tweak dwell and intensity to match.

Uvitron on UV Light Core

Uvitron UV curing lamp